Project
Pest ProofingSquirrel ControlEntry Point ExclusionExclusionCompleted September 2025

Squirrels at the chimney border, Abbotsford

Squirrels were getting in along the chimney border of an Abbotsford home, and the fix came down to flashing that could hold up over time. The final visit confirmed no activity, and the rotting wood beside the chimney was flagged for a longer-term repair.

SITE CONTEXT

Residential home in Abbotsford with a chimney border at the roofline

PROGRAM SCOPE

Squirrel entry at the chimney border, closed with flat and custom-cut flashing

DELIVERY MODEL

Five visits, from mesh replacement through a full border pest-proofing

DOCUMENTATION

Visit notes record the flashing install and a confirmed no-activity check

Squirrels getting in along a chimney in Abbotsford

A home in Abbotsford had squirrels working in at the border where the chimney meets the roofline. The gap sat in an awkward spot, with the wood around it soft in places, so anything fastened there had to find sound material to hold onto. The job was to stop the activity and close the border properly.

Temporary mesh and rotting wood at the chimney

Temporary mesh was already covering the areas of concern when the follow-up work began. Mesh can slow an animal down for a while, but it doesn't close a gap the way a solid edge does, and squirrels test anything that isn't fixed tight. Around the chimney, some of the wood had rotted, so the real question was which pieces could sit on healthy material and which areas could not be trusted to hold a fix.

Flat flashing first, then a full border around the chimney

The mesh was replaced with flat flashing over the areas of concern. The follow-up visit also checked whether squirrels had come back, so the flashing was judged by what it did, not only by how it looked. On the final visit the whole border around the chimney was pest-proofed. Each piece was measured against its run, with the 2-inch flange set tight against the chimney and the mesh sitting flush to the soffit. Smaller pieces covered the outer side, and everything was painted white before being screwed into healthier wood. The rest of the flashing was checked to make sure it stayed tight.

The Outcome

We were hired to stop squirrels getting in around the chimney and keep them out. The final visit confirmed no activity, and the border is closed.

Squirrels out, chimney border closed

  • The final visit confirmed no squirrel activity around the chimney.
  • The full border around the chimney is pest-proofed with custom-cut flashing, painted white to finish the job.
  • The flashing is fixed to the healthiest wood available, so the closure has solid material to hold it.
  • The rotting sections are still in place, and the recommendation is to replace them with fresh wood and a tight trim for a longer-term fix.

The rotting wood is the one part of this site that needs more than flashing. Replacing those sections would give the border a solid base, and a tight trim piece against the chimney would finish it cleanly. Work like this sits under our pest-proofing and squirrel control programs, where the aim is an entry that stays closed.

Some photos on this page are representative photos from similar jobs our crews have done, not photos of this property.

Need Pest Proofing?

Comprehensive exclusion audit and sealing of all entry points. The last pest service your property needs.

View Pest Proofing More pest proofing in Abbotsford
All ProjectsPest control in Abbotsford

Ready to Resolve It?

Inspection, root-cause resolution, and documented follow-up. No obligation.