Mice chewing in at the siding line of a Burnaby house
The homeowners had active mice in the house, and the signs were hard to miss. Mice were chewing, and they were pulling insulation out through gaps where the siding meets the foundation. Some do-it-yourself construction around the perimeter had left weak points, and the mice were using them to get in at ground level.
The homeowners wanted the mice out and kept out. Before any of that could happen, the perimeter had to be reachable. Stored items were piled along the outside of the home and in a rear storage area, and the team needed them moved about four feet away from the structure to seal it properly. The homeowners agreed to move everything ahead of the work.
Siding gaps, an open dryer vent and a damaged garage door
Mice don't need much room. A young mouse can squeeze through a gap of about half an inch, and the openings that matter most are often low and out of sight. Here, the siding and foundation seam was the main concern. There were several gaps along it, and the rough construction around the base of the house added more.
Two other entry points stood out. The dryer vent was open, which gave mice a direct route inside. One of the garage doors was damaged, and the homeowners didn't use that door. Our assessment called for ground-level pest proofing to stop the mice getting in, plus a targeted trapping program to remove any already sealed inside.
Sealing the ground level and setting up stations
The team went over the ground level of the house with a fine-tooth comb. They repaired entry points, cracks and chew holes, and used miscellaneous flashing along the siding and foundation seam.
The open dryer vent got a removable, rodent-proof cover. It keeps mice out and still lets the vent be cleaned.
Trapping comes after proofing because mice that got in before the sealing are still inside. The homeowners chose to handle the trapping themselves, so we set them up with six stations. On a follow-up visit, the team dropped off additional traps and checked over the earlier sealing work around the house.
The Outcome
We were hired to stop mice getting into this house and to deal with the ones already inside. The ground level is proofed, and the job was closed in early 2024.
Mouse entry points sealed at ground level
-
The siding gaps, chew holes and other ground-level openings the mice were using are sealed.
-
The open dryer vent now has a removable rodent-proof cover, so it can still be cleaned without leaving a way in.
-
The homeowners have six trapping stations in place for any mice that were inside when the house was sealed.
-
Workmanship on the sealed areas is warrantied. If mice chew a new way in within a year, the team returns to reinspect and seal it.
This job came down to three things: clearing access, sealing the structure, then trapping anything left inside. Siding seams, vents and doors are where we start any ground-level mouse problem, because that's where mice look for a way in.
Read more about our pest proofing, entry-point exclusion and rodent control services.
Some photos on this page are representative photos from similar jobs our crews have done, not photos of this property.
Need Pest Proofing?
Comprehensive exclusion audit and sealing of all entry points. The last pest service your property needs.
View Pest Proofing More pest proofing in Burnaby