Mice getting in at ground level of a Burnaby home
The homeowner had mice getting into a detached house in Burnaby, and the problem was not in the attic or along the roof. Every route the mice were using sat at ground level, where parts of the building's perimeter had started to degrade.
The brief was to close the new access points and pest-proof every degrading area for a long-term result. A trapping programme would follow to catch any mice already inside.
Degrading gaps around the base, nothing at the roof
The inspection placed the entry routes in the structural flaws around the perimeter, all at ground level. The roof needed no treatment, so the work stayed low on the building.
The problem areas were gaps in the siding, the siding corners, the rear deck, the door jambs and the places where utility lines pass through the wall. The rear door was also compromised, and mice could get in underneath it. Each of these is a small opening a mouse can squeeze through. Sealing some and leaving others would have left the house open.
A one-day perimeter seal, then trapping inside
One technician did the proofing in a single day, including shop prep and close-out. Siding gaps were spot treated, every siding corner was reinforced, and 50 feet of 1x2 perforated angle flashing went onto structural elements. The flashing is heavy-duty, and its perforations allow drainage and airflow where they're needed.
The rear deck was spot treated, and every door jamb and utility line penetration was sealed. A rodent-proof 36-inch door sweep went on the rear door to stop mice getting under it. Smaller openings were closed with 1/4-inch and 1/2-inch screen and sealants.
Trapping came next, because mice can be shut inside when the gaps are closed. We set six stations, three upstairs and three downstairs. Trapping was poison-free, with food-grade bait in secured, out-of-sight stations, so it posed no risk to children, pets or wildlife. Two trap checks followed. At each one the stations were checked, reset and rebaited, and the house was checked for new access points.
The Outcome
We were hired to close the ground-level routes mice were using to get into the house and to trap out any that were sealed inside. Both parts of the job are done.
Mouse entry points sealed
- The siding gaps, siding corners, rear deck, door jambs and utility penetrations that were letting mice in are sealed.
- A rodent-proof sweep now closes the gap under the rear door.
- Heavy-duty perforated flashing protects the structural elements while still letting them drain and breathe.
- The trapping programme ran its course after the proofing to deal with any mice shut inside.
- The proofing carries a one-year warranty on workmanship.
The roofline needed nothing, so all the work went into the ground-level perimeter. That was where this house was letting mice in. Our pest proofing work starts at the gaps the inspection actually finds. The mouse control side follows the sealing to deal with whatever is still inside.
A follow-up visit in May went back over the areas of concern noted at the previous inspection. Each service visit came with an inspection report, giving the homeowner a written record of the work.
Some photos on this page are representative photos from similar jobs our crews have done, not photos of this property.
Need Pest Proofing?
Comprehensive exclusion audit and sealing of all entry points. The last pest service your property needs.
View Pest Proofing More pest proofing in Burnaby