Project
Entry Point ExclusionMouse ControlRodent ControlPest ProofingCompleted September 2025

Flashing the siding and a one-way door in Coquitlam

Mice were getting into a Coquitlam home along the siding and at ground level. We flashed three weak stretches of siding, sealed the entry points and garage door sweep, and fitted a one-way door at the active opening.

SITE TYPE

Home with a garage, Coquitlam

PROGRAM SCOPE

About 30 feet of flashing on weak siding, entry points sealed, garage door sweep adjusted and sealed

DELIVERY MODEL

Three visits from mid-August to late September, with a one-way door fitted at the active entry point

MONITORING

Six small interior and four large exterior mouse stations

Mice getting in along the siding and at ground level

Mice were getting into a Coquitlam home through gaps along the siding and at ground level. The weak spots were spread around the house: a side pop-out, a back corner near the original entry point and the area by the front steps. The garage door sweep was also checked as a precaution. Sealing one hole would not have fixed it. The job had to close every route mice were using.

Three weak stretches of siding and a gap under the garage door

The siding needed work in three places: the side pop-out, the back corner and the stretch by the front steps. The main entry points sat near the original opening and the front steps. The existing garage door sweep also needed adjusting and sealing to close the bottom of the door. Mice travel along the base of walls, so gaps at ground level and under doors are the routes that matter most.

Flashing and sealing first, then a one-way door

On the first visit we installed about 30 feet of 2x1 inch flashing along the three weak stretches of siding. We inspected and sealed the main entry points near the original opening and the front steps, adjusted and sealed the garage door sweep, and closed any other ground-level gaps we found during the visit. We also set six small interior mouse stations and four large exterior stations.

A week later we came back and fitted a one-way door at the active entry point. Mice can leave through it but cannot get back in, so the opening is not sealed with mice still working inside. On the final visit we removed the one-way door and the traps.

The Outcome

We were hired to stop mice getting into the house by closing the ways they were coming in. The job is finished.

Mouse entry closed off

  • The weak stretches of siding at the pop-out, the back corner and the front steps are now covered with flashing.
  • The main entry points and the other ground-level gaps we found are sealed.
  • The garage door sweep is adjusted and sealed, so mice no longer have a route under the door.
  • The flashing, sealing and garage sweep were part of the work on this job.

The active opening was handled with a one-way door rather than sealed shut straight away. Mice could leave but could not return, and the door and traps came out at the close of the job.

This is the approach behind our entry-point exclusion work.

Some photos on this page are representative photos from similar jobs our crews have done, not photos of this property.

Need Entry Point Exclusion?

Professional-grade sealing of gaps, vents, soffits, and utility penetrations across the entire structure.

View Entry Point Exclusion More entry point exclusion in Coquitlam
All ProjectsPest control in Coquitlam

Ready to Resolve It?

Inspection, root-cause resolution, and documented follow-up. No obligation.