Project
Bird ControlPest ProofingEntry Point ExclusionCommercial ProgramsCompleted September 2026

Replacing Failed Bird Netting on a Vancouver Office Tower

Torn netting around a commercial tower's rooftop and window squares had opened the building back up to birds. We stripped the old mesh, rebuilt the exclusion system zone by zone, and sealed the gaps that were letting birds back in.

SITE CONTEXT

Commercial office tower, Vancouver

PROGRAM SCOPE

Rooftop, rooftop entrance, utility cover, curtain, and 9 outer window squares

MATERIALS INSTALLED

~1,495 sq ft of 2-inch netting, 570 ft airline wire, anchors, turnbuckles, posts and brackets

WARRANTY

2-year workmanship warranty plus 5-year manufacturer's warranty on netting

Torn netting around a downtown tower

A commercial tower in Vancouver had bird netting installed around its rooftop opening, rooftop entrance, a utility cover, a curtain wall section, and nine outer window squares. Over time the netting had torn and sagged in multiple spots, leaving gaps large enough for birds to get back into areas it was meant to keep clear. Anyone who has dealt with a bird problem on a commercial roof knows the netting is only as good as its weakest tear: one gap is enough for birds to find their way back to a ledge, a fan housing, or a window recess, and droppings start accumulating again almost immediately.

This kind of job comes with its own access requirements. Every technician on site needed valid fall protection certification and full fall arrest equipment, since most of the work happens on rooftop edges, curtain wall ledges, and window recesses several storeys up.

Five zones, one failing system

Once on site, the scope broke down into five distinct zones that each needed their own netting, hardware, and anchor points: the main rooftop opening, the rooftop entrance, a utility cover, a curtain wall section, and the nine outer window squares. Each zone had different geometry and different failure points. The rooftop entrance needed posts and side-mount brackets to carry the net load, the curtain and utility cover needed smaller anchor runs, and the outer squares needed the largest single run of netting and airline wire on the job. In several spots the metal brackets holding the old net in place had been rubbing directly against the mesh, which is part of why the netting had failed in those locations rather than simply aging out.

Full strip-and-rebuild of the exclusion system

The crew removed all of the existing damaged netting across the five zones and installed new 2-inch bird netting in its place, sized to the specific measurements of each area. Across the job this added up to roughly 1,495 square feet of new netting and 570 feet of airline wire, tensioned with turnbuckles and secured to the structure with anchors, posts, and brackets. Access zippers were built into the curtain and rooftop entrance sections so maintenance staff can get through the netting without cutting or re-tying it later.

Where the old brackets had been rubbing against the mesh, the crew adjusted their position so the new netting wouldn't wear through in the same spots again. The job was scoped for two technicians over three days, and most of the installation held to that, though a follow-up visit was needed to finish outstanding zipper work on a couple of sections and to widen access at a cooling fan door and a stairwell. On that follow-up, netting holes were repaired, the cooling fan door zipper was adjusted to swing fully open, and the stairs zipper was widened to allow partial access. A zipper on one tall, narrow mesh section was still outstanding at that point and flagged for scheduling.

The Outcome

We were hired to replace failing bird netting across the tower's rooftop and exterior zones and close the gaps that had let birds back in. The new netting system is installed across all five zones, and the access points maintenance staff need are built into the mesh.

New netting installed, access points in place

  • All of the torn, failing netting across the rooftop, rooftop entrance, utility cover, curtain, and nine outer window squares has been removed and replaced with new 2-inch netting.
  • Airline wire, anchors, turnbuckles, posts, and brackets were installed to the specifications each zone needed, rather than a single generic kit across the whole building.
  • Brackets that had been wearing against the old net were repositioned so the same failure point shouldn't recur in the same spots.
  • Access zippers at the curtain, rooftop entrance, cooling fan door, and stairs give maintenance staff a way through the netting without cutting it.
  • The work carries a workmanship warranty backed by the manufacturer's warranty on the netting materials.

The recommendation going forward is a twice-yearly maintenance inspection of the netting, since UV exposure, wind load, and contact with hardware are what wear mesh down over time, not a single point of failure. For buildings dealing with similar rooftop or ledge activity, our bird control and entry-point exclusion programs cover this kind of zone-by-zone assessment, and our pest-proofing work extends the same approach to other access points on a commercial envelope.

Need Bird Control?

Deterrent systems, netting, and exclusion for pigeons, starlings, and other pest bird species.

View Bird Control
All ProjectsPest control in Vancouver

Ready to Resolve It?

Inspection, root-cause resolution, and documented follow-up. No obligation.